1. Chain nizhetsya one thread.
This thread needs to be fixed. To this end, tied at the end of the thread or fishing line a small bundle (as is done when sewing), put on a scaffold beads, pass through a needle in the middle of the knot and tighten. It turns out a bundle of beads inside (Figure 1). Further, stringing beads on pattern, considering beads-knot for the first in the scheme.
Hướng dẫn tết dây với hạt: cơ bản
2. The second way to consolidate the line in the beginning.
In the first beads fastened a small and tight little bundle, the tip of a thread is left to a minimum (Fig. 2).
Then, stringing beads remaining. Their number is jealous of what you do hotit: Fenichka or a chain around his neck. If Fenichka, how many times it will swirl your hand.
To beads did not sag, stringing them so that they lay on a string tightly. At the same time, if you're really drags the thread, the chain will be crimped.
When you type a string of desired length, fasten it, that is, connect the last beads of the first, tying a knot 1 and demonstrated a fishing line a few beads (Fig. 3). The tip of the fishing line oplavte.
3. The chain drags on two filaments.
In this case there is a fishing line in half (almost all the chains are symmetrical), and stringing beads on both ends, both on different threads (Fig. 4).
If You can make the thread ends, as shown in Figure 5, we obtain a detachable chain.
If you connect it to the beads of two beads 1, we obtain a closed-end chain.
4. Do not take too long thread or fishing line - it can get messy.
If the line was ended, and the chain still need to weave, twine can lengthen. Tie the end of the fishing line a new line, as shown in Figure 6, and the tips oplavte match.
Chain in the "cross"
Typed on a string of arbitrary number of single-color beads, such as 10. Skipping to the fourth thread from the needle beads (№ 7). Delaying thread ring - a cross, again, typed single beads on the needle and introduce the needle into the responsibility fifth beads, and so on (Fig. 1).
Flowers of six petals
Typed on a string of five white, four red and one yellow beads. Skip the needle through four red beads (flower petals), and then recruit two more red beads and extend a thread through the first hole beads - "petals" center of the flower (yellow beads) and the fourth "petal" (4). Tightens the thread, making sure to type beads is not slack, and dial the next gap between the flowers - five white beads. Then proceed to the next nizaniyu florets (Fig. 2 a, b, c).
The chain of "eight"
We print on a blue thread 1, 2,3,4,5 four white, one blue 6, and two white beads of 7.8. Skip the thread in the blue beads 1, strung on the needle 9,10,11 th beads in white, blue then another 12 and two more white 13.14. Extend a thread in a hole 6-th blue beads. Formed a loop of beads tightly addictive. Further, the chain is woven by the scheme (Fig. 3). Each pair of beads located within the chain, you can replace them equal to the length of the cylinders braid.
The chain of "honeycomb"
We collect beads on a string of six: two white, one gold, two white, one gold, (1,2,3,4,5,6), skipping the needle through the first beads. Stringing two gold 7,8, 9,10,11 three white, two gold and one white 12.13 14 beads. Insert the needle in the third beads of the first link. 15.16 recruit two white, one gold 17 and one white beads and 18 extend a threaded through two adjacent gold beads of the previous level 13, 12. Pair of gold beads can also be replaced by medium-sized beads or beads (Fig. 4).
The chain of "mosaic"
In addition to the textile and nizaniya openwork nets, there is a way of weaving of beads, which manufactures somewhat resemble woven from the dense, without gaps Location beads, but done without the machine. This so-called "dense weave," or "mosaic".
For educational purposes it is best to use seed beads in two colors. Alternating rows of colored beads facilitates the development of ways of weaving.
On waxed thread recruit an odd number of beads in accordance with the scheme (Fig. 5 a) and skipping the needle into the hole 9-d (black) beads. Getting right to the left bottom of the second row of the chain, picking up a needle on a black beads and passing through the holes in the first row of beads odd - 7,5,3,1-yu (Fig. 5 b). Third row from left to right strung, he also performed as the second, but we will use the white beads. Alternating colors of beads in horizontal rows, we obtain a chain decorated with a pattern of vertical black and white stripes (Fig. 5, d).
Cord "mosaic"
To perform the first-line string type beads on a string of seven white, jumper ring, passing a needle through the holes of the first two beads (Fig. 6 a). After this, proceed to nizaniyu second row: the thread is typed on a black beads and extend a needle through 4, 6 and 1 st beads of the first row (Fig. 6 b, c). Then strung on black thread beads 11, introduce the needle into the hole 8 th beads, a white recruit biserivku 12 and then whips the scheme so that we do in the second row were seven beads 11, 8, 12, 9, 13, 10, 14 . Perform all subsequent rows are not different from the second row (Fig. 6, d, e).
Openwork flower
Invoice item "Flower" is a very good addition ornamental composition ornaments. To its petals were resilient, "flower" is desirable at the bottom of the wire or twine. All seven petals are executed sequentially, one after another. Begins weaving from the center of the flower. The principle of its implementation is clear from the scheme (Fig. 7). When nizanii "flower", but beads can be used and glass, placing it so that one of cylinders of length equal approximately to two beads. To perform the half-open "flower bud" enough to weave a total of five or six petals instead of the usual seven.
Suspension, the fringe
Element of virtually every bead jewelry is a fringe and different types of pendants, strung from beads, beads, glass beads. Spiral fringe nizhetsya as follows: when the thread is passed through the beads of the lateral link of the chain, it recruited a number of beads. Then the needle is passed through a hole beads following cell basis in the opposite direction. As a result, a loop is formed, covering the adjacent beads. Follow the loop is the same. Gradually increasing to one - two the number of beads in each loop, reaches its length, and then as gradually reducing the number of grains, can be very effective fringe, perfectly complements the chain of "cells" (Figure 8).
Skillfully alternating colored beads, and beads, you can create a wide variety of suspensions. However, the foundation of any, even the most complex suspension is always a thread loop, whose ends are fixed on the basis of the product (Fig. 9).
Chain in the cross "-2
Fold yarn in half and pass through the ends of two needles. I typed a needle in the middle of the thread four beads: red, white, red, white. Extend a needle II in the first beads of red. In this form the first link in the chain, and needles are on opposite sides of the beads. The needle I typed two beads - white and red, and the needle II one white.Skipping needle II through the red beads, pulls the thread - got a second "cross". Re-recruit the required number of beads (two and one) and continue to weave in the same sequence until the end of the chain (Fig. 10). Need to remember that when nizanii each new "cross" on the right needle gaining two beads, and the left - one. Do not forget each time to pull the thread tightly - depends on the appearance of the product.
The chain of "rings"
Fold yarn in half and pass through the ends of two igly.Dlya first link of the chain is typed in the middle of the thread six beads: one red, two white, one red and two white. Extend a needle II through the red beads. Second and subsequent units nizhem of five grains of each bead. Three beads (two white, one red) are strung on the right-hand thread, and two white on the left. Every time extend a left needle and thread through the hole of odd red) beads, strung on the right-hand thread (Fig. 11).
Based on a chain of "rings" can be the bottom of articles of various patterns. To this end, in the process of weaving used beads of various sizes and shapes, glass (Fig. 12).
Canvas "in cross"
On the basis of the chain "in the cross" can be the bottom of the cloth of different widths: "three crosses", "five" and so on. There are two ways nizaniya cloth: In the first case of netting are alternately I, then II needle, while the second - the work is performed simultaneously with two needles. The second method is more time-consuming, but indispensable if you want to narrow or expand the panel. To change the width of a beaded linen 'in the cross "will be discussed in detail in the chapter" Making souvenirs. In carrying canvases "in cross" the first row drags the same.Later proceed differently if the work is carried out over the first method, nizhem chain length of seven "crosses." In order to proceed to weaving the second row, it is necessary that both strands emerged from the second (lateral), but not the third, the top beads "cross". Therefore, in the weaving of the seventh link on one needle recruited three beads, and the other remains free. "Crosses" is closed this way: with a free needle thread is introduced into the third hole beads and delayed (Fig. 13 a). The second row is performed in stages. The thread that goes from the third beads from the top, has been postponed and is dead, and another is nizanie needle (I), the thread which came up with the bottom of the beads. It recruited three beads-ki, and the needle is inserted into the opening fifth "cross" of the previous series. So, picking up every time a loop of three beads, nizhem the entire series, and even a "cross" remain free, while the odd are connected by loops (Fig. 13 b). When he reached the end of the series, putting off the needle and continue nizanie second thread, before dead (II). Typed on her two beads and stretches the needle first through the first hole loop beads, beads and then the side of even a "cross" the first row, and finally through the third loop of beads - this way, a new "cross" the second row. Continue nizanie II needle to the end of the series, and then type in I and II of the needle for beads and a closable ring, I passed the needle through the beads, strung on the needle II. We turn over the work - threads are located in the same way as in the early nizaniya the second row. Execute the following series of the same cloth weaving the second row (Fig. 13, d).
If the cloth is woven by the second method, then, after the scandal first-wavelength range of the seven "dagger" at the top of the needle II recruited two beads, and the I - alone. The upper needle is passed first through a hole on the needle I typed beads, and then into the side beads of the sixth "cross" the first row. (Note: In contrast to the first method of weaving together all: both even and odd "crosses" the first row.) At II needle recruited two more beads, the very first tip is free and passes through the first needle from the second strand beads. Likewise, hold the rest of "crosses." The last "X" series nizhetsya the same way as in the first method of weaving (Fig. 14).
"Grid"
With the width of the product in four cells in the middle of the thread recruited 15 beads. I left the needle on the left and the needle II passed through the 9 th beads. Second row nizhem needle II, from right to left, and picking up the needle with three beads, pulled through 5 th and 1 st beads of the first row (Fig. 20 a).
Concluding the second row on the needle stringing beads, only two (22, 23), I typed the needle four beads and extend a thread through the last beads of the second series (23). Needle II remains on the left and does not participate in the work, and the needle I, which became the working left to right nizhem third row. As in the previous series, we collect the needle with three beads and passes it through a medium-sized beads of the previous (second) series (20, 17, 14).Upon completion of the third row of pins will be on opposite ends of the product (Fig. 20b). The fourth row nizhetsya as I needle from right to left. The first link of the fourth series (rotation) consists of four beads, the other links nizhutsya of three beads each and are located between the middle beads of the previous row (Fig. 20). At the end of the fourth series of dials on both the needle with two beads and closes the link, passing a needle through the last beads II of the fourth series of threaded needle I. The fifth row start to the bottom of the needle II, became a working. Thus, in the weaving of "grid" of needles alternated every two rows. The correctness of weaving can be controlled by the number of free beads extreme cells: there must be two on each side.
Connection ends "grid"
The ends of the "net" are connected by a series of links that are strung from the primary and secondary grains of beads. The main beads - this means the cells of both chains of beads. Additional grain drawn from the same material as all the product. Additional beads are marked by black color scheme. For correct connection of the end "grid" thread I and II shall come out of beads at one of the joined tuples. I typed the needle two more beads and passes it through the outermost beads of the second chain. The further course of working filaments and the location of additional beads are indicated on the diagram (Fig. 21).
Connecting the ends of the tape Gaitan, beware: Make sure that it is not twisted, otherwise connect the ends of the "grid" will again.
No comments:
Post a Comment